Home » Products » Battery Testing Machine » GT-I18 Altitude Simulation Tester

GT-I18 Altitude Simulation Tester

Application
This machine is used to simulate air transport under low-pressure condition. The cells and batteries should be stored at a pressure of 11.6 Kpa (1.68psi) or less at least six hours. The cells and batteries are qualified if there is no leakage, no venting, no disassembly, no rupture and no fire.
The equipment can automatically control the test cycle (for example, 6H), monitor the air pressure changes in the chamber throughout the process, so that it can automatically terminate the test.

Key Specification
Model GT-I18
Machine body material Cold-rolled steel sheet by high-temperature baking paint treatment
Pressure range 0.5~100KPa
Testing chamber size 500*500*500mm (W*D*H)
Shelf material SUS304# Stainless steel
Viewing window Double-layer tempered glass
Control mode PLC HMI (Human Machine Interaction)
Timing range Can be set in 0-9999H59M59S
Pressure fluctuation ≤5%
Safety protecting device Over-current protection fuse, built-in pre-over-voltage safety device, use pressure reducing valve to achieve over-voltage safety protection, automatic alarm after operation error or timing is done.
Machine size 800*900*1500mm (W*D*H)
Weight 150kg
Power supply 1∮, 220VAC±10%, 50Hz
Output power 1.5 kW
Compressed air requirement 0.6~0.8 MPa (The air compressor should be prepared by the user.)
Related products
Inquiry Form